INSPECTION ZWP 12 OF OFFSHORE STRUCTURE SAFETY EQUIPMENT & FITTINGS DURING FABRICATION PT. XYZ

Rudolf Ivan, Slamet Wiyono, Dedy Triawan Suprayogi, Hendra Hendra, Erwin Erwin, Ipick Setiawan

Abstract


Fabrication is the arrangement of work of all components of the material, whether it is plates, pipes, steel, or other metals, that are then formed and sculpted from semi-finished material until it becomes a commodity that can be mounted into a chain of industrial or construction tools. All materials will be managed, received, stored, distributed, traceable and disposed of in accordance with material handling procedures. There are two reviews for the load on rigging, namely the horizontal load and the vertical load. The process of platform manufacturing starts with the process of marking, cutting, assembling, welding, and finishing. After that, the components will be blasted and painted. Once the manufacture is done, you can go straight to the installation stage. To go through the fabrication process requires calculations to match the values allowed to avoid unwanted things. The biggest load on the rigging load is 269.6 MT, which can determine which crane will lift the load allowed or not. The maximum load that can be lifted by a crane to lift a vent boom is 346.71 MT. For permitted thickness a variety of values according to the material used.   


Full Text:

PDF

References


Cole, I. S. ((2012)). The science of pipe corrosion: A review of the literature on the corrosion of ferrous metals in soils. Corrosion Science, 56, 5-16.

Donoso, G. L. ((2009)). Magnet fall inside a conductive pipe: motion and the role of the pipe wall thickness. European Journal of Physics, 30(4), 855.

Ellenberger, P. (2014). Piping and pipeline calculations manual: construction, design fabrication, and examination. In Elsevier.

Engineer, A. S. ((2005)). Pipeline Transportation System for Hydrocarbons and Other Liquids. ASME B31.4.

Engineer, A. S. ((2005)). Process Piping. ASME B31.3.

Jack, T. R. ((1996)). External corrosion of line pipe--. A summary of research activities. Materials performance, 35(3).

Pavia, A. P. ((1997)). Effect Of Design, Fabrication, And Installation On The Structural Reliability Of Offshore Platforms. In Offshore Technology Conference. OnePetro.

Peterson, M. L. ((1993, May).). Offshore platform fabrication specification requirements. In Offshore Technology Conference. OnePetro.

Rakvin, M. M.-1. ((2014)). Evaluation of pipe wall thickness based on contrast measurement using Computed Radiography (CR). Procedia Engineering, 69, 1216-1224.

Zhou, H. Y. ((2022) ). Mitigation of welding induced buckling with transient thermal tension and its application for accurate fabrication of offshore cabin structure. . Marine Structures, 81, 103104.

Gravit, M.; Gumerova, E.; Bardin, A.; Lukinov, V. Increase of Fire Resistance Limits of Building Structures of Oil-and-Gas Complex Under Hydrocarbon Fire. Adv. Intell. Syst. Comput. 2018.

Gravit, M.; Shabunina, D. Numerical and Experimental Analysis of Fire Resistance for Steel Structures of Ships and Offshore Platforms. Fire 2022, 5, 9.




DOI: http://dx.doi.org/10.62870/timer.v2i1.26166

Refbacks

  • There are currently no refbacks.


This work is licensed under Creative Commons Attribution 4.0 International